Precision plastic mold has been able to produce camera and mobile phone plastic mold, multi-cavity small module gear precision molds and 5 micron 7800 cavity encapsulation molds, etc. Die casting has been able to produce large sophisticated escalator overall pedal pressure die casting and mould, automobile rear axle gear box car motor shell casting mold etc. Automotive covering parts mold has been able to produce the new sedan full midrange outer covering parts mould and so on has reached a quite high level.
But overall, the international mold association secretary general luo hui pointed out that, in our country is just mold production country, is not far from mould power, product five years or so the gap with the developed country, still give priority to with the medium, high-grade mold of the mixed rate accounts for only around 60%, a lot of high precision and complex mould is still dependent on imports, nearly three years more than 2 billion dollars a year. Mold commercialization rate is only about 60%, standard parts using coverage rate is only 50%.
Serious shortages of financial investment in scientific research, scientific research strength is weak, not form a public technology support system in favour of innovation. To close the gap, it is necessary to increase research and development, based on innovation, improve the quality of industry economy. At present, the development of mould industry in China is entering the important period. Manufacturing, especially in the development of the auto industry, accompanied by an expansion of the domestic mold market, foreign users to purchase mould in China and a growing number of international mould manufacturing transfer to China gradually trend is very obvious. China mold and die industry association forecast this year at home and abroad mold market continues to improve, mould industry in China will remain around 20% annual growth rate.
In 2013 China mold investment exceeds 450 billion
In 2013 the government is likely to continue to steady growth, thereby stimulating investment to accelerate growth again. According to the Chinese academy of social sciences forecast in 2012, our country in social investment in fixed assets 37.514 trillion yuan, up 20.4% from a year earlier. Growth of 19.9% in 2013, will reach 44.988 trillion yuan. From the point of the consensus forecast, two years of low growth. If the forecast according to the China investment association, in 2012, up 21% from a year earlier, rising to 24% in 2013, then 2013 investment will certainly more than $45 trillion.
On New Year's eve, the international association secretary general luo hundred hui has released the mold industry development and investment management analysis report pointed out that in recent years, domestic mold industry investment construction in full swing, as a kind of economic phenomenon, has aroused people more and more attention and recognition. Mold industrial agglomeration to optimize the industrial structure, promoting industrial upgrading and transformation of the mode of economic growth, improve the level of economic development, promote the competitiveness of the regional economy, and one party and all the people getting rich has important strategic significance.
Compared to "mould industry investment in the whole year of 2011, 50 cases in the first half of 2012 in mould industry investment regardless of the number or size times faster growth, investment in the top ten investment threshold rose to 10 billion, the second half of the investment value of the top ten are above 2.5 billion, survey data show that in the second half have signs of slowing down, but the 2012 top 100 case for hundreds of millions of investment project, overall than a sharp growth in 2011." Luo hui said, contrast Jin Mo net (www.gmold.info) 2012 mould investment fortune 100 list with 100 mould industry 50 cases double growth in 2012 from a year earlier, the RMB 3.863 quadrillion. The data are not included in the existing 5 m part of small and medium mould manufacturer's equipment investment, if 2013 Chinese investment will exceed 45 trillion yuan, so die industry accounts for about 1% of new investment, according to 1:100 impetus effect, mould industry investment scale will reach 450 billion yuan, and the investment growth need only 16% can be achieved.
