Note: The location first before running the program will move to set the reference tool.

G50 set when starting the tool to use, generally the knife tool offset value is set to zero.

The disadvantage of this approach is to be set from the knife point in a machining program, and the operation is more complex. But it provides a precise adjustment by hand from the knife-point mode of operation, and some people prefer this.

(3) with g54 ~ g59 setup origin

① test cut and measure the same steps with the foregoing.

② Press "ofset set" button, enter "coordinates" setting, move the cursor to the appropriate location, the origin of the coordinate value of the input program, press the "measure" or "Enter" key to set. As shown in Figure 4.

③ in call processing program, such as: g55 x100 z5 .... g54 default calls.

Note: If you set up and use the tool offset compensation, the best g54 ~ g59 of each parameter is set to 0, so as not to repeat mistakes. For multi-tool machining, can be set reference tool offset value in one of the g54 ~ g59 will benchmark knife tool offset compensation is set to zero, while the other knife tool offset compensation to its relative to the reference knife offset.