Shank

In order to achieve the best results, such as to make horn ds milling process to obtain satisfactory results, must choose the appropriate handle. Each 1mm radial runout will reduce the durability of the cutter, and will weaken its performance.

Universal collet chuck shank or grooved, because of its larger runout does not apply to hard milling, hydraulic expansion or contraction of the liner pad to get the best results. This is the tool and mold the system to be used in the tool horn, and horn din 6535 ha in accordance with standard tools, without exception, is designed to straight cylindrical structure type reasons. Additional clamping surface would undermine the accuracy of the tool, and affect their performance.

Cutting

Typically, the use hsc machining is possible for more than 56hrc hardness of workpiece machining. In this regard, with the proviso that the combined effect of cutting speed and temperature. For hsc, the melting point of the workpiece material must be tested at a suitable cutting speed. Generally higher than the melting point of the coating of maximum allowable temperature of the workpiece material, it must be careful. In this best aphorism is "Keep tool cooling." This means that on the one hand and the work of the contact zone must be as small as possible, on the other hand must be done at a certain speed machining, the heat was too late to make the cutting edge more than the allowable temperature coating.